8. Connect the cable screens of the bus cables to
ground via one of the earth clamps (H).
TM084041
Model J motor
TM082868
Model K motor
9. Route the wires for the module through one of the
cable glands.
TM084042
Routing the wires through a cable gland, shown on
a Model J motor
10. Fit the CIM cover.
11. If the module is supplied with an FCC label, fix the
label on the terminal box.
TM084101
FCC label placement, shown on a Model J motor
12. Fit the terminal box cover and cross-tighten the
four screws to 5 Nm.
Make sure that the terminal box cover
is aligned with the orientation of the
operating panel.
30
English (GB)
To Next Page
Loading...
