Grundfos CU 362 - Pump Alarms

Description Factory settings Own settings
Float switch -
Level sensor -
Conflicting levels -
Flowmeter -
Power meter -
User-defined relay output activated -
Hardware fault -
External fault -
Mains supply fault -
Battery backup (UPS) -
Communication fault (IO 351B) -
CIM module fault -
SCADA callback error -
Ethernet, no IP address from DHCP -
Ethernet disabled due to misuse -
SIM card fault -
User-defined sensor 1 -
User-defined sensor 2 -
User-defined sensor 3 -
Pres. sensor, discharge -
Related information
8.3.12 SCADA settings
8.5 Alarm settings
10.8 Pump alarms
Description Factory settings Own settings
Auto/On/Off switch -
Motor protection, tripped -
Common phase error -
Contactor -
Low flow -
Overtemp., PTC/Klixon (IO 351B) -
Water-in-oil sensor -
Overload -
Underload -
Latest runtime -
Max. starts/hour -
Time for service -
GENIbus com. fault (IO 111) -
IO 111 warning -
IO 111 alarm -
Ammeter -
Torque -
VFD not ready -
CUE warning -
CUE alarm -
MP 204 warning -
MP 204 alarm -
Ammeter -
Power meter -
Blocked -
70
English (GB)