Grundfos LLC 1000W - Technical Data; Disposing of the Product

Fault Cause Remedy
h) The pump is
defective.
Replace the pump.
2. The
pump
does not
stop.
a) The button on
the control box is
stuck.
Loosen the button.
b) Controller fault.
Contact Grundfos
Service.
c) The stop
electrode is too
long.
Trim the stop
electrode. Note the
minimum possible
stop point of the
pump.
3. Pump
starts and
stops in
the wrong
order.
a) Incorrect
switching function
is selected.
Move cable on
terminal block X1
from terminal 1 to
terminal 2 or vice
versa.
13. Technical data
Designation LLC 1000W
Supply voltage 1 x 230 V, 50 Hz, N, PE
Rated current Max. 6.0 A
Power 1000 W
Enclosure class, control
box
IP20
Enclosure class,
electrode bracket
IP68
Contact load, high-level
alarm, potential-free
Max. 2 A, max. 230 V
Cable length 10 m
EMC noise emission
According to EN
61000-6-3
EMC noise immunity
According to EN
61000-6-2
Max. liquid temperature 55 °C
Ambient temperature 0-40 °C
Country of origin Germany
Component Material
Electrodes Stainless steel
Electrode bracket Plastic
Cable sheath Rubber
Plug housing Plastic
14. Disposing of the product
This product or parts of it must be disposed of in an
environmentally sound way.
1. Use the public or private waste collection service.
2. If this is not possible, contact the nearest
Grundfos company or service workshop.
The crossed-out wheelie bin symbol
on a product means that it must be
disposed of separately from household
waste. When a product marked with
this symbol reaches its end of life, take
it to a collection point designated by
the local waste disposal authorities.
The separate collection and recycling
of such products will help protect the
environment and human health.
See also end-of-life information at
www.grundfos.com/product-recycling.
11
English (GB)