61
ENGLISH
SPECIAL SETTINGS
----------------------------------------------------------------------------------------------------------
Searching for digital terrestrial
TV channels manually
1 Open the menu with »MENU«.
2 Select the menu item »SOURCE SETUP« with
»
V
« or »
Λ
« and press
»OK«
to confirm.
– The »SOURCE SETUP« menu appears.
3 Select the line »Source« with »
V
« or »
Λ
«
and press
»OK«
to confirm.
Select the option »Air« with »
<
«, »
>
«, »
V
« or
»
Λ
« and press
»OK«
to confirm.
Caution:
7
The antenna power supply (line »Active
Antenna Power«) may only be switched on
if the antenna is an active indoor antenna
with a signal amplifier and it is not already
supplied with a voltage via a mains plug
(or similar supply). Otherwise you may
cause a short circuit and irreparably dam-
age your antenna.
4 Select the »Active Antenna Power«« with
»
V
« or »
Λ
«. Switch on the antenna pow-
er supply for the antenna with »
<
« or »
>
«
(»On«).
5 Select » Digital Manual Tuning« with »
V
« or
»
Λ
« and press
»OK«
to confirm.
– The menu appears.
6
Enter the channel number directly with
»
1 ... 0«.
– After the search is complete, the channels
found are displayed in the »Results« menu.
7 Press »EXIT« to finish the setting.
Tuning analogue television
channels
This setting is only necessary if you cannot re-
ceive any digital channels and you have not car-
ried out an analogue search during initial setup.
The television channels can be set directly or
using the scan.
Switching the television to
analogue reception
Note:
7
Analogue channels can be selected if the
option »Air« or »Cable« has been selected.
1 Open the »Select input source« menu with
»
«.
2 Depending on the antenna system, select the
option »Air« or »Cable« with »
V
«, »
Λ
«, »
<
«
or »
>
« as the input source and press
»OK«
to confirm.
Note:
7
Additional operations are explained in the
following sections.
Setting all analogue television
channels
Analogue channels are displayed in the channel
list after the digital channels.
Note:
7
Plug the rooftop antenna cable (for analogue
television channels) into the »ANT IN«
socket on the television.
1 Open the menu with »MENU«.
2 Select the menu item »SOURCE SETUP« with
»
V
« or »
Λ
« and press
»OK«
to confirm.
– The »SOURCE SETUP« menu appears.
3 Select the line »Source« with »
V
« or »
Λ
«
and press
»OK«
to confirm.
Select the option »Air« or »Cable« with »
<
«,
»
>
«, »
V
« or »
Λ
« and press
»OK«
to con-
firm.
To Next Page
Loading...
Need help?
General