Grundig CMS 2000 BT - Tuner Mode; Automatic­station­search­for­fm­ Radio­stations; Selecting Presets

27
ENGLISH
Automatic station search for FM
radio stations
1 Switch on the hi-fi system by pressing »8«.
2 Select TUNER with »SOURCE« on the re-
mote control or » « on the appliance.
3 For the automatic station search press and
hold »MEMORY PROG« on the remote
control for 2 seconds. .
– Display: »AUTOSCAN«.
– The device searches for up to 40 stations
with strong reception and stores them auto-
matically. After the search has finished, you
will hear the station stored at preset 01.
Notes:
7
You can cancel the automatic station search
by pressing »
7
«.
7
You can restart the automatic station search
by pressing »MEMORY PROG« until the
frequency display changes to rapid run-
through.
Setting and storing radio stations
manually
1 Set the radio station by briefly pressing
» TUN – 10–« or » TUN + 10+« repeatedly.
– Display: the frequency changes in steps of
50 kHz;
or
press and hold down » TUN – 10–« or
» TUN + 10+« until the frequency changes to
rapid run-through.
2 Save a radio station as a preset by pressing
»MEMORY PROG«, selecting the preset
with »
3
« or »4 « and then
press »PROG« to save.
3 To search and save more radio stations, re-
peat steps 1 to 2.
Selecting presets
1 Select a preset by pressing » « or » «
on the appliance or » « or » « on the
remote control.
TUNER MODE
------------------------------------------------------------------------------------------------------------------------