To Next PageTo Next Page
Need help?Do you have a question about the Grundig YACHT BOY 400 and is the answer not in the manual?
Lists test equipment and aids used for measurements.
Provides technical specifications and data for the device.
Offers operational guidance and important notes for service personnel.
Contains instructions on how to operate the device.
Details the steps for disassembling the unit.
Lists the frequency ranges the radio can receive.
Specifies the increments for tuning frequencies.
Details the intermediate frequencies used in the receiver.
Lists shortwave bands and their corresponding frequencies.
Provides the physical dimensions of the device.
Explains how stored data is retained during power interruptions.
Describes the function and use of the reset button.
Explains how to test all display segments.
Details the multifunction display and its indications.
Describes the controls and indicators on the front panel.
Identifies controls and features on the top surface of the unit.
Identifies controls and features on the right side of the unit.
Identifies controls and features on the left side of the unit.
Identifies controls and features on the rear of the unit.
Details the types and usage of the radio's antennas.
Explains power sources, battery, and mains operation.
Covers general operational aspects like volume, tone, and waveband selection.
Explains how to tune into radio stations using various methods.
Details how to select the frequency tuning increments.
Details how to set and use the automatic wake-up and sleep timer functions.
How to store, recall, and delete radio station presets.
Explains special features available in the AM reception mode.
Instructions for removing the rear panel of the unit.
Instructions for removing the front panel of the unit.
Instructions for removing the side panels of the unit.
Instructions for detaching the holding belt.
Instructions for removing and accessing the operating PCB.
Instructions for accessing the main PCB and its components.
Instructions for removing and replacing the loudspeaker.
Procedure for aligning the AM oscillator.
Procedure for aligning the Phase Locked Loop circuit.
Procedure for aligning the Beat Frequency Oscillator.
Alignment of the 2nd IF stage for AM reception.
Alignment of the 1st IF stage for AM reception.
Procedure for aligning the second AM oscillator.
Procedure for aligning the FM oscillator.
Alignment of the FM Multiplex circuit.
Alignment of the FM Intermediate Frequency stage.
Alignment of the FM pre-selector circuit.
Illustrates the component placement on the solder side of the PCBs.
Provides coordinates for locating components on the PCB.
Illustrates the component placement on the component side of the PCBs.
Lists all replaceable parts with their corresponding numbers.
General instructions covering safety, MOS, chip, and laser technology.
Safety regulations to be observed during repairs.
Electrical safety measures during service and repair.
Safety precautions related to laser components.
Safety guidelines for handling lithium batteries.
Proper handling procedures for MOS components to prevent static damage.
Specific soldering guidelines for MOS circuits.
Essential tips and practices for performing repairs.
Techniques for soldering and desoldering surface-mount chip components.
General