5. Dryer Operation
30 PNEG-1456 1 and 2 Fan Vision Series Portable Dryers
Continuous Flow Drying Mode Using Regulation of
Moisture: 5 MR SP
Full Heat Continuous Flow Operation
This section begins with Step 7 and it is assumed that Step 1 through Step 6 in the start-up procedure
described on Page 22 have been completed. In this example, we will again assume that incoming grain
moisture content is 25% and a ten point moisture removal is the grain drying goal.
7. Touch the Setup button at the bottom of the Default Operation Screen. Once the “Select Hardware
Setup Parameter to Modify” Screen is displayed, touch the Drying Mode button. When the “Drying
Mode Selection” window appears, touch the Continuous Flow button to select continuous flow drying
mode. Then, touch the Accept/Exit button and return to the “Select Hardware Setup Parameter to
Modify” Screen.
8. Touch the M/C Setup button. When the “Moisture Control Selection” window appears select the
REGULATION OF MOISTURE: 5 SP MR moisture control option. The 5 SP MR cannot be disabled
when operating in this moisture control mode.
Figure 5J
9. Press the 5 Speed Setup button. When the bracketed 5 Speed Moisture Control Setup is displayed
touch the Select Defaults button. Select the Accept/Exit button to save these settings in the computer
and return to the Default Operation Screen.
To Next Page
Loading...
Need help?
General
