SETUP STEP 1 STEP 2 STEP 3 STEP 4 CONGRATS!
4. Put the spring back on, narrow end first, and
lightly tighten the nut. The order in the axle should
be: quick release lever, spring, the whhel, another
spring and then the adjusting nut.
5. Lift up the bike and roll the wheel back. Set the
fork dropouts onto the axle.
6. Slowly tighten the adjusting nut on the outside and
check the quick-release lever to ensure it’s tight
enough. If it’s too loose, open the quick release
lever back up, tighten the adjusting nut more
and then close the quick release lever again. The
quick-release is properly tight when it requires a
lot of effort to close the lever, and the lever leaves
a mark on your hand.
1
4
5
6
To Next Page
Loading...
