CONGRATULATONS!
YOUR NEW GT BIKE IS
NOW ASSEMBLED
Before you ride, it’s important to perform a few pre-ride checks.
1. The front reflector should be pointing straight ahead, perpendicular to the
ground. The rear reflector must be pointing straight back.
2. Ensure that the wheel reflectors are snug by pulling them out slightly on the
spokes.
3. The proper height of your bicycle seat is about where your hip is. Stand next
to the bike, loosen the quick-release collar, pull the saddle up or down, and
then tighten it back up. The saddle will probably be about the same height as
your stem.
1
1
3
2
SETUP STEP 1 STEP 2 STEP 3 STEP 4 CONGRATS!
Sit on the bike, holding the brakes to make sure it doesn’t move.
When your leg is fully extended, it should have a slight bend in it.
To Next Page
Loading...
