9
Before you remove the brush bar, you will
need to remove the Power Floor head
from the extension tube. Gently pull on the
green locking ring attached to the Power
Head to remove.
Remove the extension tube from the Power
Floor by pulling gently on the green locking
ring.
Removing and cleaning the brush bar
To remove hair from the brush bar, run an
open pair of scissors down the groove to
cut the hair, then pull it out.
Never operate the Power Floor head
without the brush bar in.
Before you remove the brush bar, you will
need to remove both the battery and Power
Floor head from the product. Rotate the
latch on the side of the Power Floor head to
the ‘unlock’ position and pull out the brush
bar.
To Next Page
Loading...
