10 F320 Instruction Manual
rev 03.26.13
F320 OPERATION
Users of the F320 have up to 40 seconds to key in their
entry code.
Up to eight seconds are allowed between each
keystroke.
All digits of the entry code must be entered. Example:
If the code is 0042, the user must enter “0 0 4 2”.
If the wrong key is pressed, pressing the
*
key will
reset the keypad. The correct code can then be re-
entered.
After a correct code is entered, the red LED will turn
green and the programmed relay will activate for the
programmed time.
If the number of incorrect codes entered exceeds
the keypad lockout count, the yellow LED will light,
indicating that the keypad is locked out. The lockout
will remain for one minute.
After a valid code has been entered, it will be unusable
until the anti-passback time expires.
USERS HAVE UP TO
40 SECONDS TO ENTER
THEIR COMPLETE CODE
PRESS STAR KEY TO
RESET KEYPAD IF THE
WRONG KEY IS PRESSED
RED LED TURNS
GREEN WHEN
ACCESS IS GRANTED
YELLOW LED WILL LIGHT
DURING KEYPAD LOCKOUT IF
TOO MANY INCORRECT CODES
ARE ENTERED
Figure 10. Operating F320
To Next Page
Loading...
