GTO F320 - Page 8

8 F320 Instruction Manual
rev 03.26.13
Beep Sounds During Relay #1 Default: No
Selects whether or not the keypad beeps during Relay #1
activation.
Press: 4 1 # Sound #
Sound = 1 for Yes = 0 for No
Beep Sounds During Relay #2 Default: No
Selects whether or not the keypad beeps during Relay #2
activation.
Press: 4 2 # Sound #
Sound = 1 for Yes = 0 for No
Resetting the Master Code
STEP 1 Open the F320 case.
STEP 2 Locate jumper JP2. This jumper is used to reset the
master code.
STEP 3 With power applied to the keypad, remove jumper
JP2. The keypad will begin to beep, signaling that
the code has been reset.
STEP 4 Replace jumper JP2.
THE MASTER PROGRAMMING CODE IS NOW 123456.
Beep Sounds During Output #3 Default: No
Selects whether or not the keypad beeps during Output #3
activation.
Press: 4 3 # Sound #
Sound = 1 for Yes = 0 for No
Beep Sounds During Output #4 Default: No
Selects whether or not the keypad beeps during Output #4
activation.
Press: 4 4 # Sound #
Sound = 1 for Yes = 0 for No
Keypad Lockout Count Default: 3 Tries
Sets the number of incorrect entry code attempts allowed
before the keypad “locks out”.
Press: 5 0 # Attempts #
Attempts = Number of attempts before lockout (2-7)
Anti-passback Time Default: No Anti-passback
Sets the length of time an entry code will not function after
it is used.
Press: 5 1 # Minutes #
Minutes = Time in Minutes (1-4)
0 = No Anti-passback
Beep Sounds on Keystrokes Default: Yes
Selects whether or not the keypad beeps as each key is
pressed.
Press: 4 0 # Sound #
Sound = 1 for Yes = 0 for No
Master Reset
CAUTION: Performing a master reset will clear
the entire memory of the F320 and return all
programmable options to the factory default values.
ALL ENTRY CODES WILL BE ERASED.
STEP 1 Disconnect power from the keypad.
STEP 2 Press and hold down the
*
and # keys.
STEP 3 Apply power to the keypad, continue holding the
keys down until the red LED starts ashing.
STEP 4 Release the keys. The red and yellow LEDs will
remain lit until the process is complete, then the
yellow LED will go out.