GTO R4211 - Setting Closed Position Limit

7
Setting the Closed Position Limit
for Pull to Open Applications
TURN CONTROL BOX ON
Your GTO PRO® has two Limit Settings
1) OPEN Limit setting:(GateintheOPENPOSITION/thelimitisFACTORYSETandNOTADJUSTABLE)Theopen
limit setting is the fully open position.
2) CLOSED Limit setting:(GateintheCLOSEDPOSITION)Toachieveoptimumclosedposition,youarerequired
tocompletethefollowingFOURSTEPS:
Step 1
ConrmthatthepowerswitchisintheONpositionandthegateisintheOPENPOSITION.
Step 2
Activate your opener by pressing the entry transmitter button.
Yourgateshouldnowbemovingfromthefullyopenposition
towardtheclosedposition.PreparetoSTOPthegatebypressing
the entry transmitter button again when the gate reaches the
desired closed position. This step may be repeated until desired
close position is achieved. Once the desired CLOSED position
has been achieved, proceed to step 3.
Step 3
WiththegateinthedesiredclosedpositionPRESS&HOLD
the“LEARNMASTLIMIT"buttononthecontrolboardfor5
seconds.
Step 4
Pressthetransmitterbuttonandallowthegatetoreturntothe
fullyopenposition.YOURGATE’SCLOSEDPOSITIONLIMIT
ISNOWPROGRAMMED.
TESTING YOUR CLOSED LIMIT SETTING:
Pressyourentrytransmitterandallowyourgatetoclose.IftheCLOSEDpositionisnotcorrectorneedstobechanged,you
willneedtoCLEARyourCLOSEDLIMITsettingsandfollowSteps1-4again.
CLEARING THE PROGRAMMED CLOSED LIMIT SETTING:
If you make a mistake and set the limit at the wrong position – press your transmitter to return the gate to the fully opened
position,thenpressandholdthe"LEARNMASTLIMIT"buttonfor5seconds.Thiswillclearthememoryfortheclosed
limitposition.FollowSteps1-4again.
Learn Master Limit
Button
1 2 3 4
ON DIP
STAT US
LEARN RMT
LEARN
MAST LIMIT
LEARN
SLV LIMIT
S3
S4
S2
ART OFF
G OFF
PULL
EN DLY.
OFF
OFF
ON
ON
PUSH
SIMULT.
ON
ON
120 MIN MAX
CLOSE TIME STALL FORCE