PX/QX/RX Version 4.20 User Manual â Issue B
- 9 -
Incorrect Codes
If Easy Set is not programmed and an incorrect user code is entered, the incorrect code message will
be displayed for a few seconds or until another key is pressed. The installation engineer will have
programmed a limit on the number of incorrect code attempts that can be made. If more than the
programmed number of code attempts are made to enter a valid user code, the keypad will be locked
out and the display will show
Out of Service for a period of 5 minutes. Any attempt to enter a user
code during the locked out period will extend the period by another 5 minutes.
12:00 Mon 27 Sep
Guardall
12:00 Mon 27 Sep
Enter- ****
02 0 2 î
12:00 Mon 27 Sep
Incorrect Code
12:00 Mon 27 Sep
Out Of Service
5 Min.
Delay
Maximum Code
attempts
To Next Page
Loading...
