Gude 40588 - Troubleshooting; Inspections and Maintenance

Operator Safety Instructions
See Gene
ral Safety Instructions and Initial Operation Safety Instructions.
x Do not use the machine until you have read the instruction manual
carefully.
x
Observe any safety instructions included in the manua
l.
x
Be responsibl
e to the others
Troubles – Causes – Troubleshooting
Trouble Cause Troubleshooting
The engine will not
start up.
1.
Fuel cock closed
2. No fuel
3.
Too little oil in th
e tank
4.
Air in oil pipeline
5. Batter
y too weak
1.
Make sure that the fuel cock on/off switch are in on
position
2.
Make sure that there is enough f
uel in the tank.
3. Replenish the oil
4.
Have the oil pipeline blown throug
h
5.
Charge the battery with appropriate charger
Engine runs unevenly
1. Poor
fuel
2.
Air in oil pipeline
1.
Make sure that the used fuel is correct.
2.
Have the oil pipeline blown throug
h
No current from
generator.
x
Short circuit
x Defective cable
x Loose cable
1. If the light indicator is off, the defect is impossible to be
cleared b
y your
self. .
If the light indicator is on :
2. Press the overloading protection for the required output.
3. Check the conne
ction.
4.
Check whether a short circ
uit or overloading is not the
cause.
Inspections and Maintenance
Reg
ular cleaning and maintenance is essential for perfect functioning and long
service life of the unit.
No smoking in the course of the described jobs.
Never work close to sparks, flames or open fire.
Scheduled Maintenance and Inspections
Air Filter
The air filter should be cleaned every 50 hrs of operation.
x Loosen the service cover screwing.
x Remove the co
ver.
x Remove the air filter.
x
Clean the filter with spirit or et
hanol
x
Drop a small amount of oil on
the air filter and compress it.
x
Put the filtration cartridge back and put the housing on.
Fuel Screen
x Remove the lid from the filler hole.
x
Pull the fuel sc
reen from the filler hole.
x
Clean the filter with spirit or et
hanol
x
Dry it with a so
ft cloth.
x
Put the filter back in the filler.
x Replace the lid on the filler.
Oil Replacement
x Let the engine heat up.
x
Unscrew
the filler plug.
x
Remove the discharge screw and drain the used oil into a
suitable container.
x
Check packing and replace it if necessary. Screw the discharge screw in and pour new oil in.
x Screw the filler neck again on
.