6
NOTICE
A
LL RADIO
C
ONTROLLED
R
EMOTE
S
POTLIGHTS ARE FACTORY SET TO THE SAME SECURITY
CODE
. I
F YOU HAVE A PROBLEM WITH ANOTHER PERSON
’
S SPOTLIGHT INTERACTING WITH
YOUR SPOTLIGHT
,
OR WISH TO CHANGE YOUR SECURITY CODE FOR ANY REASON
,
FOLLOW
THE PROCEDURE OUTLINED BELOW
.
A. Disconnect Power to the spotlight.
B. Adjust Security Code (Perform steps listed below in Code switch Location and
Adjustment section).
C. Reconnect Power.
D. Within 5 seconds of reconnecting power, push transmitter buttons to register
security code.
Code Switch Location and Adjustment
The Code switch is located inside of the transmitter on the backside of the circuit board,
above the battery.
A. Remove any static charges from your body by touching a grounded metal object.
B. Remove transmitter from console mounting bracket by slightly bending the tab
back to release transmitter from bracket.
C. Remove the two screws on the back of the transmitter with a Philips screwdriver.
D. With a coin, lightly pry open the transmitter case using the slot in the bottom
corner opposite of the key ring hole.
E. Carefully separate the case halves.
F. Carefully remove the circuit board and adjust the code switch to a new setting,
(See figure A for switch location).
To Next Page
Loading...
Need help?
General