11
Operating Instructions
APPLICATION
WARNING: The saw teeth are very sharp. Do not touch during mounting and
application.
The workpiece must be clamped tightly before it is cut.
UNIVERSAL ACCESSORIES
NOTE: Accessories also work with other competitive oscillating tools.
Pic
Name Application
Sawing
Bi-Metal Metal/
Wood End Cut Blade
Wood, plastic, fiberglass,
nails, non-ferrous metals,
thin sheet metal, hardened
fillers
HSS segment saw
blade
Thin wood, plastic,
fiberglass, non-ferrous
metals, thin sheet metal,
hardened fillers, window
glazing
Sanding
Sanding base Wood, plastic, hardened
fillers
Removing
grout
Diamond-Coated
segment Saw Blade
Ceramic and stone tile,
backerboard
Scraping
Rigid Scraper Blade Old paint, hardened
adhesives, caulk, carpet
NOTE: When plunging and sawing, use a slight pendulum motion, to allow sufficient chip
removal.
The saw blade lasts longer if the wear is distributed evenly. To ensure an even distribution,
loosen the saw blade, rotate it and retighten firmly.
Cut/Sand with a constant movement and light pressure.
Heavy pressure does not increase the cut/removal rate – the accessory merely wears
faster.
Operation instructions
To Next Page
Loading...
