10
Operating Instructions
3. USING THE VARIABLE SPEED DIAL (SEE FIG. G)
Select oscillation frequency (speed) while the motor is running.
The Variable Speed Dial can be used to set the optimum oscillating frequency according to
the accessories used and the respective application.
High oscillation frequency:
Sanding, sawing, rasping and polishing stone and metal.
Low oscillation frequency:
Scraping, polishing varnishes.
4. LED (SEE FIG. H)
The LED allows you to keep a clear view under less illuminated circumstances. To turn on
the light, simply press the on/off switch. When you release the on/off switch, the light will
turned off.
5. ELECTRONIC FEEDBACK
Your tool is equipped with an internal electronic feedback system which helps to keep the
preselected speed virtually constant between no-load and load conditions.
G
H
F
Operation instructions
To Next Page
Loading...
