15
Customer Helpline 0333 3201989
If your power tool becomes too hot, please run your circular saw no load for 2-3 minutes
to cool the motor. Avoid prolonged usage at very low speeds.
Protect saw blades against impact and shock. Cutting with extreme force can significantly
reduces the performance capability of the tool and reduces the service life of the saw
blade. Sawing performance and cutting quality depend essentially on the condition and the
tooth count of the saw blade. Therefore, use only sharp saw blades that are suited for the
material being cut.
Choice of blades: 24 teeth for general work, approx. 40 teeth for finer cuts, more than 40
teeth for very fine cuts into delicate surfaces, diamond for tile, cement board, etc.
Only use saw blades recommended.
For your safety ,Please hold the handle of the saw with two hands when you are
operating the saw�
Working Hints For Your Circular Saw
Maintenance
Remove the plug from the socket before carrying out any adjustment, servicing or
maintenance�
Your power tool requires no additional lubrication or maintenance. There are no user
serviceable parts in your power tool. Never use water or chemical cleaners to clean your
power tool. Wipe clean with a dry cloth. Always store your power tool in a dry place. Keep
the motor ventilation slots clean. Keep all working controls free of dust. Occasionally you
may see sparks through the ventilation slots. This is normal and will not damage your
power tool.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a hazard.
To Next Page
Loading...
