EasyManuals Logo

GUTMANN Nivel 8000 ML Installation Instructions

GUTMANN Nivel 8000 ML
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #43 background imageLoading...
Page #43 background image
EN
43
Veneers, adhesives or plastic
coverings of adjacent furniture must
be temperature-resistant (min. 75°C).
If the veneers and coverings are not
sufficiently temperature-resistant,
they may deform.
The use of solid wood wall end strips
on the worktop behind the hob is per-
mitted, provided that the minimum
distances are observed in ac-
cordance with the installation sket-
ches.
The minimum distances of the recess
cut-outs to the rear according to the
installation sketch must be observed.
For installation directly next to a tall
cabinet, a safety distance of at least
50 mm must be maintained. The side
surface of the tall cabinet must be
covered with heat-resistant material.
For technical reasons, however, the
distance should be at least 300 mm.
The packaging materials (plastic foils,
polystyrene, nails, etc.) must be ta-
ken out of the reach of children, as
these parts represent possible
sources of danger. Small parts could
be swallowed and foils pose a suffo-
cation hazard.
Ventilation
The induction hob has a fan that auto-
matically switches on and off. If the
temperature values of the electronics
exceed a certain threshold, the fan
starts at a low speed. If the induction
hob is used intensively, the fan swit-
ches to a higher speed. If the electro-
nics have cooled down sufficiently,
the fan reduces its speed and swit-
ches off again automatically.
The distance between the induction
hob and kitchen furniture or built-in
appliances must be chosen so that
sufficient ventilation of the induction
is guaranteed.
If the power of a cooking zone often
switches down automatically or off,
the cooling is probably not sufficient.
In this case it is advisable to open the
rear wall of the base cabinet in the
area of the worktop cut-out and to
reduce the front crossbar of the furni-
ture across the entire width of the hob
to ensure better air exchange.
For better ventilation of the hob, an air
gap of at least 5 mm is recommended at
the front below the worktop.
PREPARATIONS
7. MOUNTING REQUIREMENTS - KITCHEN FURNITURE AND WORKTOP
Safety instructions for the kitchen furniture fitter

Table of Contents

Other manuals for GUTMANN Nivel 8000 ML

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GUTMANN Nivel 8000 ML and is the answer not in the manual?

GUTMANN Nivel 8000 ML Specifications

General IconGeneral
BrandGUTMANN
ModelNivel 8000 ML
CategoryVentilation Hood
LanguageEnglish

Related product manuals