Care and Maintenance
Energy Saving Tips
Moving the Appliance
Switching off the Appliance
Place the appliance in the coolest area of the room, away from heat-producing
appliances and out of direct sunlight.
Do not line any storage bin with aluminium foil, wax paper or paper towels. Liners
interfere with cold air circulation, reducing cooling efficiency.
Do not leave the door open for longer than required.
Let hot foods cool down before placing them inside. Overloading the appliance forces the
compressor to run longer.
Wrap foods properly and wipe containers dry before placing them in the appliance. This
cuts down on frost build-up inside.
Remove all the contents in the appliance.
Securely tape down any loose items inside.
Turn the levelling screws up to the base to avoid damage.
Tape the door shut.
We recommend moving the appliance in its original packaging. Otherwise, make sure to
protect the outside with a blanket or similar item during transportation.
Be sure the appliance stays in the upright position during transportation.
Do not apply force on any external part such as pipes, condenser or door when moving.
Ensure the appliance stays secure in an upright position; do not tilt it for more than 45°
from upright.
To switch off the appliance, turn the thermostat dial to position “0”. If the appliance is
not going to be used for an extended period:
Remove all items.
Switch off the appliance by turning the thermostat dial to position “0”.
Remove the mains plug, switch off or disconnect the electricity supply.
Clean thoroughly.
Leave the door open to avoid the build-up of odours.
Once the appliance has been turned off, allow it to settle down for about 10 minutes
before turning the appliance on. This will prevent the compressor from being
damaged.
To Next Page
Loading...
