GW Instek GDM-9060 Series - Setup; Connecting to GDM-9060;9061

SETUP
5
SETUP
Connecting to GDM-9060/9061
The GDM-9060/9061 can connect to the software using either the USB CDC
or the USB TMC interface. Functionally there is no difference in which
interface is chosen to interface with the PC.
Connection
1. Connect the rear panel
USB B port on the
DMM to a USB port
on the PC using a Type
A to Type B USB
cable.
C
A
L
I
B
R
A
T
I
O
N
U
S
E
O
N
L
Y
Configure the
DMM
1. Press Menu button.
2. Go to Interface tab.
3. Further go to the field of Interface.
4. Select USB option for interface.
5. Go to the field of Protocol.
6. Set the interface to either USBCDC or USBTMC.
7. Press Exit Menu to confirm the settings and exit.
Note
The baud rate does not need to be set when either USB
CDC or USB TMC interface is used.
Alternatively, the RS232 connection is the easiest way to use the add-in
software with the GDM-9060/9061 as no drivers are required.
Connection
1. Connect the rear panel RS232 port on the DMM to
a RS232 port on the PC using a RS232 crossover
cable.