Need help?Do you have a question about the GW Instek GDS-1052-U and is the answer not in the manual?
General| Bandwidth | 50 MHz |
|---|---|
| Channels | 2 |
| Sample Rate | 1 GSa/s |
| Display Type | TFT LCD |
| Timebase Range | 5 ns/div to 50 s/div |
| Power Supply | 100-240 VAC, 50/60 Hz |
| Input Impedance | 1 MΩ |
| Vertical Sensitivity | 2 mV/div |
| Trigger Modes | Edge, Pulse, Video |
| Interface | USB |
| Probes Included | 2 |
| Display | 5.6 inch |
Provides essential safety precautions for operating the oscilloscope.
Details safety instructions for using the power cord in the UK.
Provides a detailed description of the oscilloscope's front and rear panels.
Guides users through the initial setup and operational checks.
Details how to use the Autoset function for automatic configuration.
Explains running/stopping triggers and adjusting the trigger level.
Details the procedure for performing automatic measurements.
Explains how to use and move horizontal cursors for time measurements.
Explains how to use and move vertical cursors for voltage measurements.
Explains how to set upper and lower boundaries for templates.
Guides on executing the configured Go-NoGo tests.
Steps to start the data logging process.
How to select between Normal, Average, and Peak Detect modes.
Describes trigger types, parameters, sources, and modes.
Steps to configure edge trigger settings like source, mode, slope, and coupling.
Steps to configure video trigger settings like standard, polarity, and field.
Steps to configure pulse width trigger settings like condition and slope.
Shortcut to save display images, waveform data, and panel settings to USB.
Details specifications specific to different GDS-1000-U models.
Lists general specifications applicable to all models.
Specifications for probes used with GDS-1052-U and GDS-1072-U.
Specifications for probes used with GDS-1102-U.
To Next Page