Need help?Do you have a question about the GW Instek GDS-1102A-U and is the answer not in the manual?
General| Bandwidth | 100 MHz |
|---|---|
| Sample Rate | 1 GSa/s |
| Channels | 2 |
| Memory Depth | 10 Mpts |
| Weight | 2.5 kg |
| Display Resolution | 800 x 480 pixels |
| Input Impedance | 1 MΩ ± 2% |
| Vertical Sensitivity | 2mV/div ~ 10V/div |
| Trigger Modes | Edge, Pulse, Video |
| Trigger Types | Edge, Pulse, Video, Slope, Alternate |
| Interface | USB |
| Power Supply | AC 100V ~ 240V, 50Hz/60Hz |
| Display | 7 inch TFT LCD |
Provides essential safety precautions for operating and maintaining the oscilloscope.
Guides users through the initial steps to prepare the oscilloscope for operation.
Explains how to automatically configure oscilloscope settings for optimal waveform display.
Describes how to use the oscilloscope's automated measurement features.
Details how to use cursors to measure specific points on waveforms.
Covers performing mathematical calculations (Add, Subtract, FFT) on input signals.
Explains how to set up pass/fail testing based on waveform templates.
Describes how to log waveform data or images to a USB flash drive over time.
Details horizontal controls for position, scale, update modes, and zoom.
Covers configuring trigger types, sources, modes, coupling, and holdoff.
Step-by-step instructions for calibrating the oscilloscope's vertical resolution.
Procedures for compensating oscilloscope probes for accurate measurements.
To Next Page