Need help?Do you have a question about the GW Instek GDS-1102B and is the answer not in the manual?
General| Brand | GW Instek |
|---|---|
| Model | GDS-1102B |
| Category | Test Equipment |
| Language | English |
Describes how to configure the USB and Ethernet remote control interface.
Details the steps for configuring the USB interface for remote control.
Provides instructions for setting up the Ethernet interface for remote control.
Explains how to set up the socket server functionality for remote LAN communication.
Guides on testing the socket server functionality using NI MAX.
Outlines the rules and syntax for writing commands for the oscilloscope.
Lists all available commands organized by their functional categories.
Covers fundamental SCPI commands like *IDN?, *RST, *CLS.
Details commands for controlling waveform acquisition parameters and modes.
Lists commands for performing automatic measurements on waveforms.
Explains commands for configuring trigger source, type, level, and slope.
Covers commands for system settings like panel lock and error queue.
Details commands for saving and recalling instrument setups and waveforms.
Lists and explains common error codes and their meanings.
To Next Page