GW Instek GDS-1102B - Cursor:huse; Cursor:vuni

GDS-1000B Programming Manual
60
Return parameter
Returns the unit type.
Example
:CURSor:HUNI SEConds
Sets the units to time in seconds.
:CURSor:HUSE
Description
Sets the current cursor position as the phase or
ratio reference for the Percent or Degrees
(horizontal) cursors.
Note
This command can only be used when
:CURSor:HUNI is set to DEGrees or PERcent.
Syntax
:CURSor:HUSE {CURRent}
Related
Commands
:CURSor:MODe
:CURSor:HUNI
Parameter
CURRent
Uses the current horizontal position
Example
:CURSor:HUSE CURRent.
:CURSor:VUNI
Description
Sets or queries the units for the vertical bar cursors.
Syntax
:CURSor:VUNI {BASE | PERcent | ?}
Related
Commands
:CURSor:MODe
Parameter
BASE
Sets the vertical cursor units the same
as the scope units (V or A).
PERcent
Sets the displayed units to percent.
Return parameter
Returns the unit type.
Example
:CURSor:VUNI BASE
Sets the units to the base units.
Set
Set
Query