GW Instek GDS-1102B - Measurement Commands; Measurement:meas<X>:Source<X

COMMAND DETAILS
101
Measurement Commands
:MEASUrement:MEAS<X>:SOURCE<X> ..................101
:MEASUrement:MEAS<X>:TYPe ...............................102
:MEASUrement:MEAS<X>:STATE ............................102
:MEASUrement:MEAS<X>:VALue.............................103
:MEASUrement:MEAS<X>:MAXimum .....................104
:MEASUrement:MEAS<X>:MEAN ............................105
:MEASUrement:MEAS<X>:MINImum .....................105
:MEASUrement:MEAS<X>:STDdev ..........................106
:MEASUrement:STATIstics:MODe ...........................107
:MEASUrement:STATIstics:WEIghting .....................107
:MEASUrement:STATIstics .......................................108
:MEASUrement:MEAS<X>:SOURCE<X>
Description
Sets or queries the measurement source for a
selected automatic measurement. This is a statistics
related command.
Syntax
:MEASUrement:MEAS<X>:SOURCE<X> { CH1 | CH2 |
CH3 | CH4 | MATH | ? }
Related
commands
:MEASUrement:MEAS<X>:TYPe
Parameter
MEAS<X>
The automatic measurement number
from 1 to 8.
SOURCE<X>
SOURCE1: the source for all single
channel measurements.
SOURCE<X>
SOURCE2: the source for all delay or
phase measurements.
CH1 to CH4
Channel 1, 2, 3, 4
MATH
Math source
Set
Query