GW Instek GDS-1102B - Run Command; Single Command; Stop Command

GDS-1000B Programming Manual
112
Run Command
:RUN
Description
The run command allows the oscilloscope to
continuously make acquisitions (equivalent to
pressing the Run key on the front panel).
Syntax
:RUN
Stop Command
:STOP
Description
The stop command stops the oscilloscope making
further acquisitions (equivalent to pressing the
Stop key on the front panel).
Syntax
:STOP
Single Command
:SINGle
Description
The single command allows the oscilloscope to
capture a single acquisition when trigger
conditions have been fulfilled (equivalent to
pressing the Single key on the front panel).
Syntax
:SINGle
Set
Set
Set