Need help?Do you have a question about the GW Instek GDS-1102-U and is the answer not in the manual?
General| Bandwidth | 100 MHz |
|---|---|
| Sample Rate | 1 GSa/s |
| Channels | 2 |
| Record Length | 10 Mpts |
| Vertical Sensitivity | 2 mV/div to 10 V/div |
| Display Type | Color LCD |
| Display | 7 inch TFT LCD |
| Interface | USB |
General safety precautions for operating and handling the oscilloscope.
Description of the front and rear panels of the oscilloscope.
Details the controls and indicators on the front panel.
Details the connectors and ports on the rear panel.
Step-by-step guide for initial setup and configuration of the oscilloscope.
Listing of the oscilloscope's factory default panel settings.
Covers fundamental operations for capturing and viewing signals.
Procedure for enabling input channels CH1 and CH2.
Automatic configuration of settings for optimal waveform display.
How to control waveform acquisition using Run/Stop modes.
Adjusting the horizontal view of the waveform.
Adjusting the vertical view of the waveform.
Details on available automatic measurement items and their meanings.
How to display and interpret measurement results.
Using horizontal and vertical cursors for precise measurements.
Procedure for positioning and using horizontal cursors.
Procedure for positioning and using vertical cursors.
Performing arithmetic and FFT operations on waveforms.
Steps to perform addition and subtraction of signals.
Steps to perform Fast Fourier Transform analysis.
How to configure signal acquisition modes.
Choosing between Normal, Average, and Peak Detect modes.
Configuring display settings.
Adjusting horizontal parameters.
Adjusting vertical parameters for each channel.
Configuring the oscilloscope's trigger system.
Selecting trigger modes like Edge, Video, or Pulse.
Setting trigger source, line, and mode.
Detailed settings for edge trigger.
Detailed settings for video trigger.
Detailed settings for pulse width trigger.
Using the Hardcopy key as a shortcut for saving.
How to save panel setup, waveform data, and display images.
How to recall default settings, reference waveforms, panel setups, and waveform data.
Restoring the oscilloscope to its factory default configuration.
Procedure for calibrating the vertical resolution of the oscilloscope.
Procedure for compensating the oscilloscope probe.
Detailed technical specifications for the GDS-1000-U series.
Specifications for compatible oscilloscope probes.
To Next Page