GW Instek GDS-1102-U - Cursor Measurements; Using the Horizontal Cursors

MEASUREMENT
55
Cursor Measurements
Cursor line, horizontal or vertical, shows the precise position of the
input waveforms or the math operation results. The horizontal
cursor can track time, voltage and frequency, whilst the vertical
cursor can track voltage.
Using the horizontal cursors
Procedure
1. Press the Cursor key. The
cursors appear in the
display.
Cursor
2. Press X↔Y to select the
horizontal (X1&X2) cursor.
X↔Y
3. Press Source repeatedly to
select the source channel.
Source
CH1
Range
CH1, 2, MATH
4. The cursor measurement results will appear in
the menu, F2 to F4.
Parameters
X1
Time position of the left cursor. (relative to
zero)
X2
Time position of the right cursor. (relative
to zero)
X1X2
The difference between the X1 and X2.
-uS
The time difference between X1 and X2.
-Hz
The time distance converted to frequency.
-V
The voltage difference. (X1-X2)
Moving the
horizontal
cursors
To move the left cursor, press
X1 and then use the Variable
knob.
X1
123.4us
212.0mV