Need help?Do you have a question about the GW Instek GDS-1072-U and is the answer not in the manual?
General| Display Type | 7-inch TFT LCD |
|---|---|
| Bandwidth | 70 MHz |
| Sample Rate | 1 GSa/s |
| Channels | 2 |
| Vertical Resolution | 8 bits |
| Timebase Range | 5 ns/div to 50 s/div |
| Input Coupling | AC, DC, GND |
| Power Supply | 100-240 VAC, 50/60 Hz |
| Input Impedance | 1MΩ || 16pF |
| Trigger Modes | Edge, Pulse, Video |
| Interface | USB |
| Vertical Sensitivity | 2mV/div ~ 10V/div |
Identifies safety symbols used in the manual and on the oscilloscope.
Provides essential safety rules for operating and handling the oscilloscope.
Details the function of each button, knob, and display element on the front panel.
Provides a step-by-step guide for initial setup and configuration of the instrument.
Lists the factory default panel settings for quick restoration.
Describes how the Autoset function automatically configures the oscilloscope for optimal viewing.
Explains how to start, stop, and manage the trigger function for waveform acquisition.
Describes trigger types, parameters, and specific configurations for edge, video, and pulse triggers.
Step-by-step guide on how to save instrument panel settings to memory or USB.
Explains how to save waveform data from channels or math operations.
Details how to save the current screen display as an image file.
Covers saving panel settings, display images, and waveforms simultaneously.
How to restore the oscilloscope to its factory default settings.
Procedure for calibrating the vertical resolution of the oscilloscope.
Steps to adjust the probe for accurate waveform measurements.
Detailed technical specifications for the GDS-1000-U series models.
Technical details for the GDS-1052-U, GDS-1072-U, and GDS-1102-U probes.
To Next Page