7. Press Slope repeatedly to
select the trigger slope,
which also appears at the
bottom of the display.
Rising edge, falling edge
8. Press Coupling repeatedly to
select the trigger coupling.
9. Press Rejection to select the
frequency rejection mode.
10. Press Noise Rej to turn the
noise rejection on or off.
11. Press Previous menu to go
back to the previous menu.
Manually triggering the signal
Note: This section describes how to manually
trigger the input signals when the oscilloscope
does not capture them. This section applies to the
Normal and Single trigger mode, since in the Auto
trigger mode, the oscilloscope keeps updating the
input signal regardless of the trigger conditions.
To Next Page
Loading...
