GW Instek GDS-1072-U - Configuring the Pulse Width Trigger

GDS-1000-U Series User Manual
90
Configuring the pulse width trigger
Procedure
1. Press the Trigger menu key.
MENU
2. Press Type repeatedly to
select pulse width trigger.
The pulse width trigger
indicator appears at the
bottom of the display.
Type
Pulse
3. Press Source repeatedly to
select the trigger source.
Source
CH1
Range
Channel 1, 2, Ext
4. Press Mode repeatedly to
select the trigger mode,
Auto or Normal. To select
the Single trigger mode,
press the Single key.
Mode
Auto
SINGLE
Range
Auto, Normal
5. Press When repeatedly to
select the pulse condition.
Then use the Variable knob
to set the pulse width.
When <
20.0ns
VARIABLE
Condition
> , < , = , ≠
Width
20ns ~ 10s
6. Press Slope/Coupling to set
trigger slope and coupling.
Slope /
Coupling