GW Instek GDS-1072-U - Default Settings

QUICK REFERENCE
43
Default Settings
Here are the factory installed panel settings which
appear when pressing the Save/Recall key→
Default Setup.
Default
Setup
Save/Recall
Acquisition
Mode: Normal
Channel
Scale: 2V/Div
Invert: Off
Coupling: DC
Probe attenuation
voltage: x1
BW limit: Off
Channel 1 & 2: On
Cursor
Source: CH1
Cursor: Off
Display
Type: Vectors
Accumulate: Off
Grid: Full
Horizontal
Scale: 2.5us/Div
Mode: Main Timebase
Math
Type: + (Add)
Position: 0.00 Div
Measure
Item: Vpp, Vavg, Frequency, Duty Cycle, Rise
Time
Trigger
Type: Edge
Source: Channel1
Mode: Auto
Slope:
Coupling: DC
Rejection: Off
Noise Rejection: Off
Utility
Hardcopy: SaveImage,
InkSaver On
ProbeComp: Square
wave, 1k, 50% duty cycle
Go-NoGo
Go-NoGo: Off
Source: CH1
When:
Violating: Stop
Data Logging
Data logging: Off
Source: CH1
Setup: Waveform
Interval: 2 secs
Duration: 5 mins