GW Instek GDS-1102A-U - Configuring the Edge Trigger

GDS-1000A-U Series User Manual
98
Pressing Set to Minimum
sets the Holdoff time to the
minimum, 40ns.
Holdoff
40.0ns
Note: The holdoff function is automatically
disabled when the waveform update mode is
in Roll mode.
Configuring the edge trigger
Procedure
1. Press the Trigger menu key.
MENU
2. Press Type repeatedly to
select edge trigger.
Type
Edge
3. Press Source repeatedly to
select the trigger source.
Source
CH1
Range
Channel 1, 2, Line, Ext
4. Press Mode repeatedly to
select the Auto or Normal
trigger mode. To select the
single trigger mode, press
the Single key.
Mode
Auto
SINGLE
Range
Auto, Normal
5. Press Slope/coupling to enter
into the trigger slope and
coupling selection menu.
Slope /
Coupling
6. Press Slope repeatedly to
select the trigger slope,
rising or falling edge.
Slope
Range
Rising edge, falling edge