GW Instek GDS-1102A-U - Manually Triggering the Signal

GDS-1000A-U Series User Manual
102
10. Press Noise Rej to turn the
noise rejection on or off.
Noise Rej
Off
Range
On, Off
11. Press Previous menu to go
back to the previous menu.
Previous
Menu
Manually triggering the signal
Note: This section describes how to manually
trigger the input signals when the oscilloscope
does not capture them. This section applies to the
Normal and Single trigger mode, since in the Auto
trigger mode, the oscilloscope keeps updating the
input signal regardless of the trigger conditions.
To acquire the
signal regardless
of trigger
conditions
To acquire the input signal
regardless of the trigger
condition, press the Force key.
The oscilloscope captures the
signals once.
FORCE
In the Single
trigger mode
Press the Single key to start
waiting for the trigger
condition. To break out of the
Single mode, press the
Run/Stop key. The trigger
mode changes to the Normal
mode.
SINGLE
Run/Stop