The input signal does not appear in the display.
I want to remove some contents from the display.
The waveform does not update (frozen).
The probe waveform is distorted.
Autoset does not catch the signal well.
I want to clean up the cluttered panel settings.
The accuracy does not match the specifications.
The oscilloscope will not allow a 2M waveform to be saved.
The input signal does not appear in the display.
Make sure you have activated the channel by pressing the CH key
(page 46).
I want to remove some contents from the display.
To clear the math result, press the Math key again (page 62).
To clear the cursor, press the Cursor key again (page 60).
To clear the Help contents, press the Help key again (page 45).
To Next Page
Loading...
