GDS-2000A Series User Manual
32
5. The installation will complete in a few seconds.
When finished a pop-up message will appear
asking you to restart the GDS-2000A.
6. Restart the GDS-2000A.
Power Up
The GDS-2000A accepts line voltages of 100 ~ 240V
at 50 or 60Hz.
1. Connect the power cord to
the rear panel socket.
2. Press the POWER key. The
display becomes active in
~ 30 seconds.
: ON
: OFF
The GDS-2000A recovers the state right before the
power is turned OFF. The default settings can be
recovered by pressing the Default key on the front
panel. For details, see page 202.
To Next Page
Loading...
