GW Instek GFG-3015 - Page 47

GFG-3015 p.43
Command Function
Parameter
Arguments
:SOURce:SWEep:SPACing
Set the method of sweep
<NR1> <0>Linear
<1>LOG
:SOURce:SWEep:SPACing ?
Check the method of
sweep
None
:SOURce:TRIGger:RATe
Set the value of trigger
rate
<NRf> Numeric data
:SOURce:TRIGger:RATe ?
Check the value of
trigger rate
None
:SOURce:TRIGger:STATe
Set the trigger state
<NR1> <1>ON
<0>OFF
:SOURce:TRIGger:STATe ?
Check the trigger state
None
:SOURce:TRIGger:PHASe
Set the value of trigger
phase
<NR1> Numeric data
:SOURce:TRIGger:PHASe ?
Check the value of
trigger phase
None
:SOURce:TRIGger:MODe
Set the trigger mode
<NR1> <0>Single
<1>Mutiple
:SOURce:TRIGger:MODe ?
Check the trigger mode
None
:SOURce:TRIGger:SOURce
Set the trigger source
<NR1> <0> Internal
<1> External
:SOURce:TRIGger:SOURce ?
Check the trigger source
None
:SOURce:TRIGger: SYM
Set the value of trigger
SYM
<NR1> Numeric data
:SOURce:TRIGger: SYM ?
Check the value of
trigger SYM
None
:SOURce:COUNter:GATe
Set the gate time of
counter
<NR1> <0>001sec
<1>01sec
<2>1sec
<3>10sec
:SOURce:COUNter:GATe ?
Check the gate time of
counter
None
:SOURce:COUNter:SOURce
Set the counter source
<NR1> <0> Internal
<1> External
:SOURce:COUNter:SOURce ?
Check the counter
source