FUNCTION GENERATOR -SERIES
INSTRUCTION MANUAL
following:
(1) Series connect a R1 to the network under test as in Figure 9.
(2) Get voltage read out in E1, E2, adjust R1 until E2 is equal to one
half of E1.
(3) Under this frequency, the impedance network is the same as the
R1.
(G)Act as automatic test of speaker
Because there provide the auto feature in this equipment, the output can
drive to amplifier for testing the frequency response of speaker.
(a) Set Auto/Manual to Auto position.
(b) Set function to Sine wave
(c) Set Range to 20kHz
(d) Sweep mode (LIN, LOG), sweep width, sweep time can be set in
any value.
(e) The line connected is showed in Figure 11.
FUNCTION GENERATOR -SERIES
INSTRUCTION MANUAL
l FIGURE 4
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
