Need help?Do you have a question about the GW Instek GDM-906 Series and is the answer not in the manual?
General| Category | Digital Multimeter |
|---|---|
| Continuity Test | Yes |
| Diode Test | Yes |
| Measurement Functions | DC Voltage, AC Voltage, DC Current, AC Current, Capacitance, Frequency, Temperature, Diode, Continuity |
| DC Voltage Range | 100mV to 1000V |
| AC Voltage Range | 100mV to 750V |
| DC Current Range | 100µA to 10A |
| AC Current Range | 100µA to 10A |
| Resistance Range | 100Ω to 100MΩ |
| Temperature Range | -200 °C ~ +200 °C |
| Connectivity | USB |
| Power Supply | AC 100 V ~ 240 V, 50 Hz ~ 60 Hz |
Provides general safety guidelines for operating and handling the instrument.
Step-by-step instructions for safely replacing AC source fuses.
Procedure for replacing the instrument's internal battery (CR2032).
Procedure for performing AC and DC voltage measurements.
Procedure for performing AC and DC current measurements using 3A and 10A terminals.
Instructions for performing 2-wire and 4-wire resistance measurements.
How to perform continuity tests to check for conductive paths.
Procedure for testing diode forward bias characteristics.
How to measure the frequency or period of an input signal.
Procedure for measuring capacitance of a component.
How to store a reference value and measure the delta between readings.
Function to retain current measurement data and update when it exceeds a set threshold.
Configuration for automatic or single triggering of measurements.
Introduces math operations like dBm, dB, Compare, MX+B, 1/X, and Percent.
Function to check if measurement data stays within specified upper and lower limits.
Procedure for updating the instrument's firmware.
How to configure screenshot capturing mode and save files.
Accessing and using the web interface for instrument control and monitoring.
SCPI commands for performing various measurements on the primary display.
SCPI commands for controlling measurement triggering and delay.
SCPI commands for configuring LAN, GPIB, and RS232 communication interfaces.
Standard IEEE 488.2 common commands for instrument control.
Step-by-step guide on how to replace instrument fuses safely.
Procedure for replacing the internal battery (CR2032) of the instrument.
Detailed technical specifications of the instrument.
Detailed specifications specific to the GDM-9061 model.
Detailed specifications specific to the GDM-9060 model.
To Next Page