GW Instek GDM-906 Series - Configure RS232 Interface

REMOTE CONTROL
205
Set the USB Protocol
Description
The USB device port on the rear panel is used for remote
control. The USB port can be configured as either a
TMC or CDC interface.
Before the GDM-9060/9061 can be used for remote
control utilizing the CDC or TMC USB class, install the
appropriate CDC or TMC USB driver included on the
User Manual CD.
USBCDC:
The USB port on the GDM-9060/9061 will appear as a
virtual COM port to a connected PC.
USBTMC:
The GDM-9060/9061 can be controlled using National
Instruments NI-Visa software*. NI-Visa version 3.0 and
above supports USB TMC.
NOTE
*To use the TMC interface National Instruments
Measurement and Automation Explorer can be used.
This program is available on the NI website,
www.ni.com., via a search for the VISA Run-time Engine
page, or “downloads” at the following URL,
http://www.ni.com/visa/
Configure RS232 Interface
RS232
Configuration
Connector
D-sub 9 pin, male
Baud rate
115200/57600/38400/19200/9600
Data bits
8
Parity
none
Stop bits
1
Flow control
none, RTS/CTS, DTR/DSR
Step
1. Press the Menu key, and then
the Page Down key repeatedly
until the Interface configuration
menu appears.