GW Instek GDM-906 Series - General Temperature Setting

BASIC MEASUREMENT
55
General Temperature Setting
F2 (Speed) key
to select the rate
Press the F1 ~ F3 key to select the desired rate
F3 (Auto Zero)
key to enable
Auto Zero
Background
Autozero provides the most
accurate measurements, but requires
additional time to perform the zero
measurement. With autozero
enabled (On), the GDM-9060/9061
internally measures the offset
following each measurement. It then
subtracts that measurement from
the preceding reading. This prevents
offset voltages present on the
GDM-9060/9061’s input circuitry
from affecting measurement
accuracy. With autozero disabled
(Off), the GDM-9060/9061
measures the offset once and
subtracts the offset from all
subsequent measurements.
Display
When turning On the Auto Zero, the display
shows an icon indicating the Auto
Zero mode is currently being activated.
F4 (Unit) key to
select unit of
temperature
Press the F4 (Unit) key to enter the Temperature
Unit menu followed by clicking the F1 – F3 key to
choose desired temperature unit. See the figure
shown below.