GW Instek GDM-906 Series User Manual

GDM-906X Series User Manual
238
3. The View & Modify Configuration page allows you to:
 View the instrument name, firmware revision of
the Ethernet card, IP address and MAC address.
 Set the IP address to DHCP or static.
 Configure the module host name and the
parameters of TCP & telnet.
 Modify the web password.
 Restore the Ethernet to the factory default
settings (equivalent to the INIT function).
 Reset: reboot to make the new setting take effect
when any parameter is modified.
Command Syntax
Compatible
Standard
IEEE488.2
Partial compatibility
SCPI, 1994
Partial compatibility
Command
Structure
SCPI (Standard Commands for Programmable Instruments)
commands follow a tree-like structure, organized into nodes.
Each level of the command tree is a node. Each keyword in a
SCPI command represents each node in the command tree.
Each keyword (node) of a SCPI command is separated by a
colon (:).
For example, the diagram below shows an SCPI sub-structure
and a command example.
:DCAC:DC :AC
CONFigure:VOLTage:DC
:VOLTage
CONFigure
Command
Types
There are a number of different instrument commands and
queries. A command sends instructions or data to the unit and
a query receives data or status information from the unit.
Command types
Simple
A single command with/without a parameter
Example
CONFigure:VOLTage:DC

GW Instek GDM-906 Series Specifications

General

Brand	GW Instek
Model	GDM-906 Series
Category	Measuring Instruments
Language	English