GDM-906X Series User Manual
334
3. The fuse holder comes out. Replace the fuse inserted at
the end of the holder followed by rotating the fuser
holder clockwise to fasten it firmly.
Replace Internal 3A/10A Input Current Fuse
Replace internal
3A input fuse
If there is still a damaged fuse in 3A input
current, follow the instructions in the
following section to replace fuse of internal
3A input current.
Replace internal
10A input fuse
(GDM-9061 only)
To make sure if 10A input current needs to
be replaced, press the button to set
GDM-9060/9061 in Continuity mode and
short circuit the HI input terminal with the
10A input current terminal. If the test result
shows OPEN, follow the following section
to replace fuse of internal 10A input
current.
To Next Page
Loading...
Need help?
General
