GW Instek GDM-906 Series - Power up

GETTING STARTED
25
Power Up
Steps
1. Ensure the correct line voltage is
clearly shown on the fuse socket
(240V in the right figure for
example). If not, see page 332 to
set the proper line voltage and fuse.
2. Connect the power
cord to the AC
Voltage input.
Note
Make sure the ground connector on the power cord is
connected to a safety ground. This will affect the
measurement accuracy.
3. Push the power button
until click to turn on the
main power switch on
the front panel.
4. The screen firstly shows the logo brand of
GWINSTEK followed by the message “Load the
default parameter” indicating default parameter is loaded
in the initial startup.