Need help?Do you have a question about the GW Instek GPS-1830 and is the answer not in the manual?
General| Output Voltage | 0 - 18V |
|---|---|
| Output Channels | 1 |
| Current Resolution | 10mA |
| Ripple & Noise (CC) | ≤ 3mArms |
| Load Regulation (CV) | ≤ 0.01% + 3mV |
| Display | LED |
| Operating Temperature | 0°C to 40°C |
Details main supply voltage, rating, dimension, and weight for different models.
Specifies output voltage range, line/load regulation, recovery time, and ripple/noise.
Details output current range, current regulation, and ripple/noise specifications.
Describes the digital type display, resolution, and accuracy of the indicator meter.
Specifies insulation resistance between chassis and output terminals, and chassis and AC cord.
Details front panel controls like CV/CC indicators, voltage/current adjustment knobs, and output terminals.
Describes rear panel connectors for AC input, programming, and switches for line voltage selection.
Covers essential safety precautions for AC input, installation, ambient temperature, and output voltage.
Step-by-step guide to setting the maximum safe current limit for the device being powered.
Explains the automatic crossover operation between Constant Voltage (CV) and Constant Current (CC) modes.
Instructions for Single, Series, Parallel operation, and remote control of output voltage and current.
Guidance on replacing blown fuses, including warnings and correct fuse types and ratings.
Procedure for converting the unit to operate on different AC line voltages using rear panel switches.
Instructions for readjusting voltage and current settings, requiring a multimeter for calibration.
Recommendations for cleaning the power supply using mild detergent and water, avoiding harsh chemicals.
To Next Page