REMOTE CONTROL
149
Sweep Commands
SWEEP:DATA:STATus ........................................................................ 149
SWEEP<X>:DATA:SHOW ................................................................... 150
SWEEP:GRAPh:SHOW ........................................................................ 151
SWEEP :GRAPh:LINE .......................................................................... 151
SWEEP:STARt:TIME ............................................................................. 152
Returns the sweep mode, the voltage and current
settings and the number data points that are used
in the last sweep. There can be a maximum of 190
data points, depending on the testing time.
The data is returned as a string in the following
format:
SWEEP MODE,VSET,ISET,Get Data[#data points].
SWEEP MODE, VSET+unit, ISET+units,
Get Data=number of data points
SWEEP:DATA:STATus?
>ACW,V=0.108kV,HI=10.96 mA ,Get Data=011
w ww . . co m
information@itm.com1.800.561.8187
To Next Page
Loading...
Need help?
General
