GW Instek GPT-9902A - Page 33

OPERATION
33
Menu Tree Overview
VIEW status
VIEW status is used to view the parameters of
the selected manual test/automatic test. The
VIEW status is also used to put the tester into
MANU or AUTO mode.
I R G B A CW D CW
E
F R E Q = 0 H z 6
0 100
k V
EIV
MT I E = 0 0 1 . 0 SR
0 0 m AER F =# 0 .0
1 . 0 0 m AIH ES = 0T
0 0 . 1 S0A M P =R
A U T O = 0 0 1 - 0 0 2
W
VIEW status
MM A UN N A_2M A N U = * * * - 0 0
MA U OT N A_
m A
E
EDIT status
EDIT status is used to edit the manual test or
automatic test parameters. Pressing the
EDIT/SAVE key will save any changes.
Pressing the ESC key will cancel any changes.
I R G B A CW D CW I / LH O I M ET R
E
F R E Q = 0 H z 6
0 100
k V
IDE
MT I E = 0 0 1 . 0 SR
0 0 m AER F =# 0 .0MM A UN N A_
1 . 0 0 m AIH ES = 0T
0 0 . 1 S0A M P =R
T
2M A N U = * * * - 0 0
EDIT status
m A
READY status
When the tester is in READY status, it is ready
to begin testing. Pressing the START button
will begin testing and put the tester into TEST
status. Pressing the MANU/AUTO key will
return the tester to VIEW status.
I R G B A CW D CW
E
F R E Q = 0 H z 6
0 100
k V
AER
MT I E = 0 0 1 . 0 SR
0 0 m AER F =# 0 .0
1 . 0 0 m AIH ES = 0T
0 0 . 1 S0A M P =R
D
MM A UN N A_2M A N U = * * * - 0 0
READY status
Y
m A
w ww . . co m
information@itm.com1.800.561.8187