GW Instek LCR-6020 - Figure 5-6 Sequential Mode

LCR-6000 Series User Manual
63
Sequential mode[SEQ]
Figure 5-6 Sequential mode
● Includes the point
○ Excludes the point
In Sequential mode, the comparison limit values are
based on the absolute value of the measurement. The
nominal value does not need to participate in operation.
To set up the comparator limit mode
Step 1. Press the [Setup] key.
Step 2. Press the [BIN SETUP] soft-key.
Step 3. Use the cursor key to select [MODE] field.
Step 4. Use the soft-keys to select comparator mode.
Soft-key
Function
ABS
Absolute parameter values
PER
Deviation percentages
SEQ
Sequential mode